Zettelstore Administrator Console manual configuration manual zettelstore zmk 00001004000000 00001004059900 00001007031000 00001018000000 00001004000000 00001004010000 00001004051000 00001004059900 00001007031000 00001018000000 1 (c) 2020-present by Detlef Stern 00010101000000 00001004010000 00001004051000 00001004101000 en EUPL-1.2-or-later 20211103162926 20211103162926 public The administrator console is a service accessible only on the same computer on which Zettelstore is running. It allows an experienced user to monitor and control some of the inner workings of Zettelstore. You enable the administrator console by specifying a TCP port number greater than zero (better: greater than 1024) for it, either via the command-line parameter -a or via the admin-port key of the startup configuration file. After you enable the administrator console, you can use tools such as PuTTY or other telnet software to connect to the administrator console. In fact, the administrator console is not a full telnet service. It is merely a simple line-oriented service where each input line is interpreted separately. Therefore, you can also use tools like netcat, socat, etc. After connecting to the administrator console, there is no further authentication. It is not needed because you must be logged in on the same computer where Zettelstore is running. You cannot connect to the administrator console if you are on a different computer. Of course, on multi-user systems with encrusted users, you should not enable the administrator console. Enable via command line Enable via configuration file List of supported commands